0-100 mm Stainless Hardened Caliper/Electronic Digital Caliper/
Small Calipers For measuring
If you want to know more about our products,pls click caliper.pdf
How to use a caliper???
The First Step
Before you take a reading—and I mean before you take every
reading—close the caliper and make sure the reading is 0.000. If
not, do this:
1. Open the jaws about three quarters of an inch. Then use the
thumb of your free hand to wipe off the mating surfaces of the
2. Close the caliper again. On an electronic digital caliper, if
the reading is not 0.000, press the zero button so that it does
read 0.000. To zero a dial caliper, rotate the bezel so that the
needle points to 0.
Four Basic Readings
Your caliper can take four kinds of readings: outside, inside,
depth, and step. Any caliper, whether it is a vernier caliper, dial
caliper, or electronic digital caliper, can take these
measurements. Let’s take a look at how you take each of those
Outside measurements are the most basic you can do with a caliper.
Slide the jaws open, place the caliper over the object to be
measured, and slide the jaws until they contact the workpiece. Read
It’s easy, but if you don’t do it correctly the measurement will
not be accurate. If the calipers are not straight (that is,
perpendicular to the workpiece) the measurement will not be
accurate. Likewise, if there is dirt on the jaws or the workpiece
the measurement will not be accurate.
The smaller jaws on the top of the caliper are used for inside
measurements. Slide the caliper closed, place the inside-measuring
jaws into the space to be measured, and slide the jaws apart as far
as they will go. Read the measurement.
It’s a little harder to keep things lined up correctly when you are
taking an inside measurement. Be sure that the calipers are not
cocked, or you will not get an accurate measurement.
As you open the caliper the depth blade extends out of the far end.
Use this blade to take depth measurements. Press the machined end
of the caliper against top of the hole you want to measure. Open
the caliper until the depth blade contacts the bottom of the hole.
Read the measurement. It can be tricky keeping the caliper straight
over the hole, especially if only one side of the caliper is
resting on the workpiece.
Step measurement is the hidden use of a caliper. Many instructions
skip this important use. But once you know about it, you will find
many uses for step measurement.
Open the caliper slightly. Place the sliding jaw on the upper step
of the workpiece , then open the caliper until the fixed jaw
contacts the lower step. Read the measurement.
Our Featured products:
- Precision Digital Caliper
- Electronic Digital Caliper
- Stainless Steel Caliper
- Magnetic Base Stand
- Digital Outside Micrometer
- Digital Height Gauge
- Dial Indicator Gauge
- Magnetic Hooks
Packaging & Shipping
Why choose us
1.Specialized in precision mold and mold part,inquires will get
highly attention and be promt response.(within 24 hours)
2.Advanced facilities and experienced engineers,rich experience in
3.Guaranteed quality,superior material quality compared to all
4.Customer oriented,efficient solution to control the cost for our
5.One-stop service,any questions can be solved at the first time by
6.Each part has been got 100% test and tryout before shipment.
7.We are golden supplier.
Contact person:Vicky Wang
Welcome to talk with me directly!